NewAir CC-300 Use and Care Manual download pdf (Page 6)

http://www.NewAir.com

INSTALLATION

This cooler is a freestanding unit and should not be installed inside a cabinet or

other built-in enclosure.

For proper ventilation, allow 5 inches clearance between the back of the unit

and any adjacent walls.

Before operating your cigar cooler for the first time, follow these steps:

 Before connecting the unit to a power source, allow it to stand upright for

approximately 2 hours. This will reduce the possibility of any system

malfunctions which may have occurred from handling during transportation.

 Clean the interior surface of the unit with lukewarm water and a soft cloth

but do not get the wood wet.

 Place the cooler on a level surface that will be strong enough to support the

unit when it is fully loaded. To level your cooler, adjust the front feet located

at the bottom of the unit.

 Install the cooler away from direct sunlight and heat sources such as stoves,

heaters, or radiators. Direct sunlight may affect the unit’s acrylic coating,

and nearby heat sources can increase electrical consumption. Extreme cold

or hot ambient temperatures may also prevent proper performance.

 Please note: this cooler is only designed for home use, and is not designed to

be placed in a garage, basement, or outdoor area

FACTORY ODOR REMOVAL

Wash the interior of the cooler with a mild detergent and warm water. Make

sure to not get the wood wet. Leave the door open and allow it to air dry

thoroughly. If a “plastic” smell persists, place a dish of baking soda in the unit or

stuff the cooler with newspapers overnight. When finished, let the unit run a full

day to complete the airing out process.

DRAWER SET-UP

The drawers and shelves included with this cooler are designed to sit flush with

the front edge of the cabinet. This will allow air to circulate freely through the

1 2 3 4 5 6 7 8 9 10 11 12

No comments

NewAir CC-300 Use and Care Manual Page 6