NewAir CC-121E Instruction Manual download pdf (Page 6)

http://www.NewAir.com

ASSEMBLY & INSTALLATION

HANDLE ASSEMBLY

Tools Required for Assembly: Phillips screwdriver (not included)

Estimated Assembly Time: 5 minutes

Before installation, attach the handle to the front of the unit with the included

screws. It may be necessary to push aside the rubber seal on the inside of the

door to reveal the screw holes.

Caution: Avoid over-tightening the screws, or you may cause damage to the

unit.

INSTALLATION

This cooler is freestanding unit and should not be installed inside a cabinet or

other built-in enclosure.

For proper ventilation, allow 5 inches clearance between the back of the unit

and any adjacent walls.

Before operating your cigar cooler for the first time, follow these steps:

 Before connecting the unit to a power source, allow it to stand upright for

approximately 2 hours. This will reduce the possibility of any system

malfunctions which may have occurred from handling during transportation.

 Clean the interior surface of the unit with lukewarm water and a soft cloth.

 Place the cooler on a level surface that will be strong enough to support the

unit when it is fully loaded. To level your cooler, adjust the front feet located

at the bottom of the unit.

 Install the cooler away from direct sunlight and heat sources such as stoves,

heaters, or radiators. Direct sunlight may affect the unit’s acrylic coating,

and nearby heat sources can increase electrical consumption. Extreme cold

or hot ambient temperatures may also prevent proper performance.

 Please note: this cooler is only designed for home use, and is not designed to

be placed in a garage, basement, or outdoor area

1 2 3 4 5 6 7 8 9 10 11 12

No comments

NewAir CC-121E Instruction Manual Page 6